Power Outage - GE JSP28 Use & Care Manual

The clock must be set for the automatic oven timing
functions to work properly. The time of day cannot be
changed during a Timed Bake or CLEAN cycle.
Timer
9
The timer is a minute timer;
it does not control oven operations.
The maximum setting on the timer
hours and 55 minutes.
is
To Reset the Timer
DECREASE pad until desired time is reached.
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
The end of cycle tone is a series of 3 beeps followed
by 1 beep every 6 seconds. If you would like to
remove the signal that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every 6 seconds. press

Power Outage

After a power outage, when
me shown will no longer be correct—for example, after a 5-minute power
"-" ;
All other t'unctions that were in operation when the power went out will
have to be programmed again.
C L O C K
To Set the Clock
n 2.
To Set the Timer
n 2.
1. Press the TIMER
TIMER
ON/OFF pad.
A
or DECREASE pad
to set the amount of
time on the timer.
To Cancel the Timer
Press the TIMER ON/OFF pad while the word
"TIMER" is flashing.
Display Messages
If "DOOr" appears in the display, the door is open.
Close the door. If "LOCK" appears in the display, the
oven door is in the locked position. BAKE, BROIL
and COOK TIME cannot be set if the door is in the
locked position.
1. Press the CLOCK pad.
pad to set the time of day.
The timer will start automatically
within a few seconds of releasing
the pad. The timer, as you are
setting it, will display seconds until
1 minute is reached. Then it will
Press the INCREASE
display minutes and seconds until
10 minutes is reached.
After 10 minutes, it will display
hours ("HR" now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
Press the INCREASE or DECREASE
9