GE Appliances Profile PFDS450 Owner's Manual And Installation Instructions page 42

Installation Instructions
I_ INSTALL BRACKET TO DRYER
A. Align the holes in the left bracket with the holes
in the bottom left corner of the dryer. Use o
Phillips screwdriver to install the 2 #12 x 1"
topping screws.
B. Repeat the above step with the right bracket
on the bottom right corner of the dryer.
C. Set the dryer upright.
NOTE: Make sure to set the dryer on a piece of
packing material so the brackets that ore attached
to the bottom of the dryer do not damage the floor.
ioi
[_] INSTALL DRYER AND BRACKET
ON WASHER
At
Lift the dryer on top of the washer. Be careful
not to scratch the top of the washer with the
brackets. Protect the washer control panel with
cardboard or other protection. Be sure to lift
the dryer high enough to clear the washer
control panel.
WARNING
- Potential
Personal Injurg. More than two people are
recommended to lift the drger into position
because of its weight and size. Failure to do
so could result in personal injurg or death.
B. Align the holes in the bracket with the holes
in the back of the washer. Using a Phillips
screwdriver, attach the 2 #8 x 1/2" topping
screws. Repeat on both sides of the washer.
/
[_] FINALIZE THE INSTALLATION
At Refer to the washer Installation Instructions
to complete the washer installation.
B.
eL
Refer to the dryer Installation Instructions
to complete the dryer installation.
Carefully slide or walk the stocked washer and
dryer into place. Use felt pods or other sliding
device to assist moving and to protect flooring.
ik WARNING - Potential Personal
Injury. Do not push on the dryer once installed
to top of the washer. Pushing on the dryer mag
result in pinched fingers.
Place
hands
here...
00° tl;
Place
__.._ hands
--- here
42