GE Appliances Profile PFDS450 Owner's Manual And Installation Instructions page 35

Installation Instructions
REVERSING THE DOOR SWING (if desired}
BEFORE YOU START
Unplug the dryer from its electrical outlet.
rl] REMOVE THE DOOR ASSEMBLY
Remove the side hinge cap by opening
the dryer door and removing the screw from
behind the hinge (#8 x .375" tapping screw). Then
using your hand, pop the hinge cap off the dryer.
lxC
/
o
/
/
Hinge
ITI REMOVE THE DOOR ASSEMBLY (cont.)
Close and hold the door, remove the 2 hinge screws
(#10 x 0.75" tapping screws). Pull the door away
from the dryer front panel.
J
i
/ i
r_ DISASSEMBLE THE DOOR ASSEMBLY
Lay the door down on a soft, protected, flat
surface so that the inner part faces upward
(door resting on the handle side).
Remove the 7 screws (#10 x 1.125" tapping
screws) located around the perimeter of the door.
Turn the door assembly over and separate
the chrome cover from the inner door. Put
the inner door aside on a soft, protected flat
surface.
35