GE Appliances JGB500 Owner's Manual And Installation Instructions page 32

Using the self-cleaning oven.
The oven door must be closed and all controls set correctly for the cycle to work properly.
How to Delay the Start of Cleaning
I SELF I Make sure theclock shows thecorrect time
%
of day.
E_] on models with Gas/Control Lockout,
touch and hold the GaslControl Lockout
pad for 3 seconds to turn it off.
NOTE: The surface burners must be turned
off prior to the self-clean start time.
%FFlE]EEEE
C_L L_out
DELAY
START
FqD ITIF-ILD
[_ Ifyour model has a latch, latch
the door.
[_] Touch the Self Clean pad.
E_] using the number pods, enter the
desired clean time.
[] Touch the Delay Start pad. The earliest
start time you can set will appear in the
display.
161 Using the number pads, enter the time
of day you want the clean cycle
to start.
When the LOCKEDDOOR light is off,
slide the latch handle to the left as far
as it will go and open the door. If your
range does not hove a latch, the door
will unlock automatically.
The words LOCKDOORwill flash and the
oven control will signal if you set the cleon
cycle and forget to close the oven door or
forget to latch the door on models with
a latch.
, To stop o cleon cycle, touch the Clear/Off
pad. When the LOCKEDDOOR light goes
off, indicating the oven has cooled below
the locking temperature, unlatch the door
(on models with a latch) and open the door.
[Z] Touch the Start pad.
On models without a door latch, the door
locks automatically. The display will show the
start time. It will not be possible to open the
oven door until the temperature drops below
the lock temperature and the LOCKEDDOOR
light goes off.
The oven shuts off automatically when the
cleon cycle is complete.
After a Clean Cycle
You may notice some white ash in the oven.
Wipe it up with a damp cloth offer the
oven cools.
If white spots remain, remove them with a
soap-filled scouring pod and rinse thoroughly
with o vinegar and water mixture.
These deposits are usually a salt residue
that cannot be removed by the cleon cycle.
If the oven is not cleon offer one cleon cycle,
repeat the cycle.
You cannot set the oven for cooking until
the oven is cool enough for the door to
unlock.
While the oven is self-cleaning, you can
touch the Clock pad to display the time
of day. To return to the cleon countdown,
touch the Cooking Time pad.
If the rocks become hard to slide, apply a
small amount of vegetable oil or cooking oil
to a paper towel and wipe the edges of the
oven rocks with the paper towel.
32