Ipod Stand - Marantz M-CR603 User Manual

iPod stand

You can set your iPod or iPhone on the supplied iPod stand.
n Setting up the iPod stand
Use the procedure below to set up the iPod stand.
q
w
e
n Setting your iPod on the iPod stand
Pass the iPod cable through
1
the opening on the iPod
stand.
Connect the iPod to the iPod cable.
2
Set your iPod on the iPod
3
stand.
NOTE
• Make sure to place the iPod stand on a fl at surface.
• Do not operate the iPod or iPhone while it is set on the iPod stand.
Doing so could cause the iPod or iPhone to fall off from the stand.
• Some iPod models cannot be set on the iPod stand because the
underside of the iPod is blocked when the iPod cable is connected.
• Make sure to disable the iPhone vibration function before you set it
on the iPod stand. If the iPhone vibrates when it is set on the stand,
it could fall off from the stand and be damaged.
• Do not use the iPod stand for purposes other than the one it is
intended to perform.
• Marantz will accept no responsibility whatsoever for any damage of
equipment connected to this unit while it is used.
n If the iPod stand becomes detached
Assemble as shown below.
ENGLISH
9