Connections; Speaker Connections; Connecting The Speaker Cables - Marantz M-CR603 User Manual

Cd
Hide thumbs Also See for M-CR603:
Table of Contents

Advertisement

Connections

This section explains how to connect speakers, recording
equipment, antennas and network.
For other connections, see the sections below.
n The wireless receiver connection (vpage 27)
NOTE
• Do not plug in the power cord until all connections have been
completed.
• When making connections, also refer to the user guide of the other
components.
• Be sure to connect the left and right channels properly (left with left,
right with right).
• Do not bundle power supply cords together with connection cables.
Doing so can result in humming or noise.

Speaker connections

Audio cable (sold separately)
Pin-plug cable
(Black)
Speaker cable
q
w
w
q
R
L
Set the speaker output for the unit to match the speaker connections
made to terminals A and B (vpage 33 "Setting speaker output").
The default setting is SPEAKER A.
NOTE
Be sure to lower the audio volume before making speaker settings.

Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to the unit, and be
sure to connect the channels and polarities correctly.
Peel off about 10 mm of sheathing
1
from the tip of the speaker cable, then
either twist the core wire tightly or
apply solder to it.
Turn the speaker terminal
2
counterclockwise to loosen it.
Insert the speaker cable's core wire to
3
all the way into the speaker terminal.
Turn the speaker terminal clockwise
4
to tighten it.
Input terminals
NOTE
• Use speakers with an impedance of 6 to 8 Ω. The protection circuit
may be activated if speakers with an impedance other than specifi ed
are used.
• Connect the speaker cables so they do not stick out of the speaker
terminals. The protection circuit may be activated if the wires
touch the rear panel or if the + and – sides touch each other
(vpage 6 "Protection circuit").
Subwoofer with
• Never touch the speaker terminals while the power supply is
built-in amp
connected. Doing so could result in electric shock.
ENGLISH
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents