Connecting An Antenna; Dab - Marantz M-CR603 User Manual

Connecting an antenna

FM/AM
• Connect the FM antenna or AM loop antenna supplied with the unit
to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
(vpage 16 "Tuning in Broadcast Stations"), fi x the antenna with
tape in a position where the noise level becomes minimal.
FM indoor antenna
(Supplied)
Black White
q w e
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• If the signal has noise interference, connect the ground terminal
(GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.
n AM loop antenna assembly
Put the stand section
1
through the bottom of
the loop antenna from
the rear and bend it
forward.
Insert the projecting part
2
AM loop antenna
into the square hole in
(Supplied)
the stand.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Standing alone
Use the procedure shown upper to assemble.

DAB

Stand
n Connecting the DAB indoor antenna
Square
"Tuning in DAB stations" (vpage 17).
hole
Loop
Projecting
antenna
part
Nail, tack, etc.
ENGLISH
DAB indoor antenna (Supplied)
7