SATO TG3 Series Quick Manual page 37

Level adjustment
Detection sensors
* Wireless LAN IEEE 802.11b/g
The board comes with a wired LAN connector. However, the simultaneous use of a wireless connection and
wired connection is not possible.
** Contact your SATO Regional Sales Manager or Reseller for availability.
NOTE
Regarding registered trademarks and trademarks of other companies:
QR Code is a registered trademark of Denso Wave Incorporated.
TG3 Series Quick Guide
Specification
(1) Paper gap adjustment
(2) Pitch sensor level adjustment
(3) I-mark sensor level adjustment
(4) Gap sensor level adjustment
(5) Ribbon sensor level adjustment
(6) Print density adjustment
(7) Side hole sensor level adjustment
(8) Notch sensor level adjustment
(9) Jump hole sensor level adjustment
(1) I-mark sensor (reflective type)
(2) Gap sensor (transmissive type)
(3) Center hole sensor
(4) Side hole sensor
(5) Notch sensor
(6) Jump hole sensor
Section 6: Basic Specifications
Page 6-7