5.
From the ribbon supply spindle, pass the carbon ribbon underneath the thermal head to the ribbon take-up
spindle. Wind the ribbon around the take-up reel several times in the direction of the arrow. Confirm that
the ribbon has been loaded as shown in the figure below when viewed from the side.
Figure showing the paper and ribbon path
6.
Lock the head-lock lever, and then close the cover.
TG3 Series Quick Guide
Ribbon
Paper
CAUTION
•
The thermal head and the surrounding area will
become hot immediately after a printing operation.
Take care not to burn yourself if you need to replace
the carbon ribbon immediately after a printing opera-
tion.
•
Touching the edge of the thermal head with your
bare hands may result in injury.
Head lock lever
Section 4: Loading the Ribbon
Page 4-3