SATO TG3 Series Quick Manual page 35

Installed functions
Self-diagnosis functions
Dimensions and Weight
TG3 Series Quick Guide
Specification
(1) Status report function
(2) Graphics function
(3) Sequential numbering function
(4) Form overlay function
(5) Non-standard character store function
(6) Black/white inverse function
(7) Line/box drawing function
(8) Formal store function
(9) Zero slash selection function
(10) JIS/Shift-JIS selection function
(11) Tag stock/label paper automatic feeding function (with
support for not issuing blank tag/label)*
(12) Eject cut function
(13) Item cut function
* There are restrictions on the tags and labels that can be
used with the automatic feeding function (no waste of first tag
or label). When the tags or labels exceed the maximum
length, automatic feeding is possible, but the first tab or label
will be blank.
Tags/labels for which the first tag or label is not wasted
Tag or Label Type
Center Hole Tag
I-Mark Tag or Label
Side Hole Tag
Edge (tag)
Label with Gap
(1) Broken head element check
(2) Paper end detection
(3) Test print
(4) Ribbon end detection
(5) Ribbon near-end detection
(6) Kanji data check
(7) Head open
(8) Lid latch open
(9) Cutter error
(10) Stacker full (when option is installed)
(11) Take-up spindle full (when option is installed)
Outer dimensions:
Width: 11.18 inches / 284 mm
Depth: 21.65 inches / 550 mm
Height: 11.81 inches / 300 mm
Weight: Approximately 30.86 pounds / 14 kg
Section 6: Basic Specifications
Maximum Length
5.51 inches / 140 mm
2.55 inches / 65 mm
7.87 inches / 200 mm
2.55 inches / 65 mm
2.75 inches / 70 mm
Page 6-5