IBM System x3650 M3 4255 Service Manual page 275

- Legacy Thunk Support
Select this choice to enable or disable the server firmware to interact with
PCI mass storage devices that are not UEFI-compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Disabled is the default.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and host name; define
the static IMM IP address, subnet mask, and gateway address; specify
whether to use the static IP address or have DHCP assign the IMM IP
address; save the network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
– Adapters and UEFI Drivers
Select this choice to view information about the adapters and drivers in the
server that are compliant with EFI 1.10 and UEFI 2.0.
v Network
Select this choice to view or configure the network options, such as the iSCSI,
PXE, and network devices. There might be additional configuration choices for
optional network devices that are compliant with UEFI 2.1 and later.
v Storage
Select this choice to view or configure the storage devices options. There might
be additional configuration choices for optional storage devices that are compliant
with UEFI 2.1 and later.
v Video
Select this choice to view or configure the video device options installed in the
server. There might be additional configuration choices for optional video devices
that are compliant with UEFI 2.1 and later.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Setup utility menu only.
v Start Options
Select this choice to view or change the start options, including the startup
sequence, keyboard NumLock state, PXE boot option, and PCI device boot
priority. Changes in the startup options take effect when you start the server.
The startup sequence specifies the order in which the server checks devices to
find a boot record. The server starts from the first boot record that it finds. If the
server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Chapter 6. Configuration information and instructions
257