IBM System x3650 M3 4255 Service Manual page 135

Table 10. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, "Parts listing, Types 4255, 7945, and 7949 server," on page 157 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
The Processor CPU nStatus has
Failed with FRB1/BIST condition.
(n = microprocessor number)
The Processor CPU nStatus has
a Configuration Mismatch.
(n = microprocessor number)
Error A processor failed - FRB1/BIST
condition has occurred.
Error A processor configuration
mismatch has occurred.
1. Check for a UEFI firmware
update.
Important: Some cluster
solutions require specific code
levels or coordinated code
updates. If the device is part
of a cluster solution, verify
that the latest level of code is
supported for the cluster
solution before you update
the code.
2. Make sure that the installed
microprocessors are
compatible with each other
(see"Installing a
microprocessor and heat sink"
on page 240 for information
about microprocessor
requirements).
3. (Trained service technician
only) Reseat microprocessor
n.
4. (Trained service technician
only) Replace microprocessor
n.
(n = microprocessor number)
1. Make sure that the installed
microprocessors are
compatible with each other
(see "Installing a
microprocessor and heat sink"
on page 240 for information
about microprocessor
requirements).
2. (Trained service technician
only) Replace the
incompatible microprocessor.
Chapter 3. Diagnostics
117