IBM System x3650 M3 4255 Service Manual page 166

Table 10. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, "Parts listing, Types 4255, 7945, and 7949 server," on page 157 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
DHCP[%1] failure, no IP address
assigned.
(%1 = IP address,
xxx.xxx.xxx.xxx)
Remote Login Successful. Login
ID: %1 from %2 at IP address %3.
(%1 = user ID; %2 =
ValueMap(CIM_Protocol
Endpoint.ProtocolIFType;
%3 = IP address, xxx.xxx.xxx.xxx)
Attempting to %1 server %2 by
user %3.
(%1 = Power Up, Power Down,
Power Cycle, or Reset;
%2 = IBM_ComputerSystem
.ElementName;
%3 = user ID)
Security: Userid: '%1' had %2
login failures from WEB client at
IP address %3.
(%1 = user ID;
%2 = MaximumSuccessive
LoginFailures (currently set to 5 in
the firmware);
%3 = IP address, xxx.xxx.xxx.xxx)
Security: Login ID: '%1' had %2
login failures from CLI at %3.
(%1 = user ID; %2 =
MaximumSuccessive
LoginFailures (currently set to 5 in
the firmware);
%3 = IP address, xxx.xxx.xxx.xxx)
Remote access attempt failed.
Invalid userid or password
received. Userid is '%1' from WEB
browser at IP address %2.
(%1 = user ID; %2 = IP address,
xxx.xxx.xxx.xxx)
Remote access attempt failed.
Invalid userid or password
received. Userid is '%1' from
TELNET client at IP address %2.
(%1 = user ID; %2 = IP address,
xxx.xxx.xxx.xxx)
148
IBM System x3650 M3 Types 4255, 7945, and 7949: Problem Determination and Service Guide
Info A DHCP server has failed to
assign an IP address to the IMM.
Info A user has successfully logged in
to the IMM.
Info A user has used the IMM to
perform a power function on the
server.
Error A user has exceeded the
maximum number of
unsuccessful login attempts from
a Web browser and has been
prevented from logging in for the
lockout period.
Error A user has exceeded the
maximum number of
unsuccessful login attempts from
the command-line interface and
has been prevented from logging
in for the lockout period.
Error A user has attempted to log in
from a Web browser by using an
invalid login ID or password.
Error A user has attempted to log in
from a Telnet session by using an
invalid login ID or password.
1. Make sure that the network
cable is connected.
2. Make sure that there is a
DHCP server on the network
that can assign an IP address
to the IMM.
No action; information only.
No action; information only.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.