Boss BR-1200CD Owner's Manual page 102

Editing a recorded performance (Track Edit)
If you are using MOVE + INS, it will not be possible to
specify the same track as the source and destination.
4. Use [CURSOR] and the TIME/VALUE dial to choose
the tracks and V-Tracks to be used as the source and
destination.
fig.15-30d
If a name has been assigned to the selected track, it will
be displayed at this time.
5. If you want to move audio on other tracks using the
same settings (for range, position, etc.), move the cursor
to the position shown below and turn the TIME/
VALUE dial.
fig.15-31d
You will now be able to specify other tracks as the source
and destination of other move operations.
However, any track that has elsewhere already been
targeted as a move-destination track cannot be newly
selected as the move-destination track.
If you want to cancel the move for a specific track, turn
the TIME/VALUE dial counterclockwise until a
question mark (?) is displayed.
• A move operation will not be performed for any line
containing one or more question marks.
• As Tracks 9/10 and 11/12 are stereo tracks, it will not be
possible to select either of their mono tracks independent
of the other.
6. Press [F3] (LOC).
The Time Setting screen will appear.
fig.02-0481d
102
7. Use [CURSOR] and the TIME/VALUE dial to specify
the move range and destination positions.
fig.15-32d
Pressing [F1] (DISP) at this time will allow you to select
how positions will be specified (i.e., by measure, time, or
marker).
The following parameters should now be set.
START (Start point):
This parameter is used to specify the start point of the
audio data to be moved.
END (End point):
This parameter is used to specify the end point of the
audio data to be moved.
TO (To point):
This parameter is used to specify the basic destination
point.
FROM (From point):
This parameter is used to specify the point within the
source audio data to be aligned with the To point.
Normally, this is set to the same value as the Start point.
• If time values are used to specify the above points and
you then switch the specification method to measures or
markers, a plus (+) character may be displayed to warn
that the indicated positions and actual positions are not
the same. If you want to specify points using measures
or markers, this discrepancy can be eliminated by using
the TIME/VALUE dial to make settings in each of the
relevant screens.
• If you want to set the move range as extending from the
start to the end of the song, press [F2] (ALL).
8. When you have made all of the necessary settings,
press [F3] (GO).
The audio data will now be moved, and when the
message "Complete!" appears, it indicates that this
operation has been completed.
9. Press [EXIT/NO] several times to return to the top
screen.