Table of Contents
Advertisement
A–Simple Network Management Protocol (SNMP)
Management Information Base (MIB)
Parameter
System contact
Authentication traps
SNMP Trap Configuration
SNMP trap configuration supports setting up to eight trap destinations. Choose
from Traps 1 through 8 to configure each trap.
parameters for configuring an SNMP trap.
Parameter
Trap n enabled
Trap address
Trap port
Trap version
Traps (other than 0.0.0.0) and trap port combinations must be unique. For example, if trap 1 and
a
trap 2 have the same address they must have different port values. Similarly, if trap 1 and trap 2
have the same port value, they must have different addresses.
Management Information Base (MIB)
The following sections describe the QLogic management information base (MIB).
The MIB consists of four object groups:
"System Information" on page A-3
"Network Port Table" on page A-4
"Fibre Channel Port Table" on page A-6
"Sensor Table" on page A-8
A-2
Table A-1. SNMP Properties (Continued)
Specifies the name of the person to be contacted to respond to
trap events. The name can be up to 64 characters excluding
the number sign (#), semicolon (;), and comma (,). The default
is undefined.
Enables or disables authentication trap generation in response
to authentication failures. The default is disabled.
Table A-2. SNMP Trap Configuration Parameters
Enables or disables trap n. If disabled, the trap is not configured.
Specifies the IP to which the SNMP traps are sent. A maximum of
a
eight trap addresses is supported. The default for traps is 0.0.0.0.
The port number on which the trap is sent. The default is 162.
a
Specifies the SNMP version (1 or 2) with which to format traps.
Description
Table A-2
describes the
Description
ISR645610-00 B
Advertisement
Table of Contents
