Isns - Qlogic iSR6152 User Manual




NOTE:

iSNS

The iSNS area of the iSCSI port Information page includes the following:
 Select the Enable iSNS check box to enable (or clear the check box to
disable) iSNS support. If iSNS is disabled, complete the following:


ISR645610-00 B
IPv6 Default Router identifies the default router for the IPv6.
Depending on your network configuration, SANsurfer Router Manager
can also dynamically set the IPv6 default router.
IPv6 Link Local specifies the IPv6 link local of the port. It is not
editable.
VLAN IPv6 indicates the VLAN IPv6 configuration as Disabled or
Enabled. When enabled, you can configure the following:
 VLAN ID IPv6 contains an identification value in the range 0 to
4094.
 Priority IPv6 defines the priority assigned to this VLAN IPv6. To
set the priority, select a value from 0 to 7.
IPv6 support is available only with hardware version 6 and later and
software version 2.4.0.0 and later.
Select either the IPv4 Server or IPv6 Server as the IP version
assigned to the IP server.
In the Server IP Address box, type the IP assigned to the iSNS server
with which this port will communicate.
3–Viewing Router Information
iSCSI Ports
3-19