Step2 Turning On The Gps Logger Function - Icom ID-51A Basic Instructions

STEP 2 Turning ON the GPS Logger function
q Push [MENU] to enter
the Menu screen.
Push D-pad( ) to select the
w
root item (GPS), and then
push D-pad(Ent) to go to the
next level.
D-pad
(Ent)
(�)
( MENU > GPS > GPS Logger
> GPS Logger)
Refer to the menu sequence
e
shown directly above and
push D-pad() to select, and
then push D-pad(Ent) to en-
ter, one or more times until
the last screen is displayed.
r Push D-pad() to select
"ON."
Push [MENU]
t
Menu screen.
• The GPS Logger starts.
<About log file>
You can display your route as you move, if you import the log
file into a mapping software.
• You can see your route on the software map. The files may not be
compatible with all mapping software.
• See the PDF type Advanced Instruction for copying the log file to
your PC.
NOTE:
• Once the GPS logger function is turned ON, the trans-
• When the microSD card is full, this function will be auto-
Go to step r
GPS LOGGER FUNCTION
to exit the
ceiver continuously stores the position data from the
GPS receiver, even if the transceiver is rebooted. To can-
cel this function, turn the function OFF.
While this function is ON, and when the transceiver is
turned OFF, the log file will be closed. Then the trans-
ceiver is turned ON and positioning is carried out by the
GPS receiver, a new log file will be created.
matically paused.
12
12
46