Table of Contents
Advertisement
Assembly
To assemble the jointer:
1.
Fasten each cabinet support to the mobile
base chassis with a
threading the bolts though the bottom of the
chassis, as shown in figure 7.
Chassis
Cabinet
support
figure 7. Cabinet supports fastened to chassis.
2.
Fasten the bottom plate to the mobile base
chassis with (8) m6-1 x 12 flange bolts, 6mm
flat washers, and m6-1 hex nuts, as shown in
figure 8.
x 8
Bottom
plate
figure 8. Bottom plate installed.
-16-
⁄
"-16 x 1" hex bolt,
3
8
x 4
3.
Fasten the top plate to the cabinet supports
with the (4)
⁄
"-16 x 1" hex bolts, as shown in
3
8
figure 9, so the flat side is up and the single
elliptical slot is on the wheel side of the cabi-
net.
x 4
figure 9. top plate installed.
4.
secure the left and right panels to the cabinet
supports with (20) #10-24 x
as shown in figure 10.
Note: The two holes on the left panel below
the dust chute slot should face down. The
right panel should be installed with the two
block holder holes facing up.
left panel
holes
figure 10. left and right panels installed.
Model G0654 (Mfg. Since 9/07)
v-Belt slot
⁄
" flange screws,
3
8
right panel
x 20
push
Block
holder
holes
Advertisement
Table of Contents
