Table of Contents
Advertisement
Surface planing
the purpose of surface planing on the jointer is
to make one flat face on a piece of stock (see
figures 45 & 46). this is a necessary step when
preparing a workpiece to be run through a planer
when squaring stock.
NOTICE
If you are not experienced with a jointer,
set the depth of cut to 0", and practice
feeding the workpiece across the tables as
described. This procedure will better pre-
pare you for the actual operation.
figure 45. typical surface planing operation.
figure 46. illustration of surface planing results.
-28-
To surface plane on the jointer:
1.
read and understand SEcTION 1: SAfETy,
beginning on page 6.
2.
make sure your stock has been inspected
for dangerous conditions as described in the
Stock Inspection & Requirements instruc-
tions, beginning on page 26.
3.
set the cutting depth for your operation. (We
suggest
⁄
" for surface planing, using a more
1
32
shallow depth for hard wood species or for
wide stock.)
4.
make sure the fence is set to 90˚.
5.
if the workpiece is cupped (warped), place
it so the concave side is face down on the
surface of the infeed table.
6.
start the jointer.
failure to use push blocks when surface
planing may result in cutterhead contact,
which will cause serious personal injury.
Always use push blocks to protect your
hands when surface planing on the jointer.
7.
With a push block in each hand, press the
workpiece against the table and fence with
firm pressure, and feed the workpiece over
the cutterhead.
Note: If your leading hand (with push block)
gets within 4" of the cutterhead, lift it up and
over the cutterhead, and place the push
block on the portion of the workpiece that is
on the outfeed table. Now, focus your pres-
sure on the outfeed end of the workpiece
while feeding, and repeat the same action
with your trailing hand when it gets within 4"
of the cutterhead. To keep your hands safe,
DO NOT let them get closer than 4" from the
cutterhead when it is moving!
8.
repeat Step 7 until the entire surface is flat.
Model G0654 (Mfg. Since 9/07)
Advertisement
Table of Contents
