Table of Contents
Advertisement
16. loosen the motor or cutterhead pulley set
screws and move the pulleys in or out as
needed to bring them into alignment.
17. tighten the pulley set screws.
18. lower the motor to increase belt tension,
tighten the motor mount bolts and recheck
pulley alignment.
19. install the front panel (figure 19) onto the
cabinet with (10) #10-24 x
making sure the panel is installed on the
same side as the motor fan.
x 10
figure 19. Front panel installed.
20. install the switch assembly onto the front
panel with (4) #10-24 x
shown in figure 20.
figure 20. switch installed.
Model G0654 (Mfg. Since 9/07)
⁄
" flange screws,
3
8
⁄
" flange screws, as
3
8
21. attach the dust port to the left cabinet panel
and dust chute with (4) #10-24 x
screws, as shown in figure 21.
figure 21. dust port installed.
22. thread (2) #10-24 x
way into the cabinet right panel, slide the
push block holder over the screws, secure
the arm with a third #10-24 x
then tighten all the screws (see figure 22).
x 3
figure 22. push block holder installed.
3
⁄
" flange
8
⁄
" flange screws half
3
8
⁄
" flange screw,
3
8
arm
-19-
Advertisement
Table of Contents
