Table of Contents
Advertisement
To set the 45˚ outward fence stop:
1.
pull the plunger out (see figure 74 on page
41).
2.
using a sliding bevel adjusted to 135˚, adjust
the fence to the 135˚ (45˚ outward) position,
as shown in figure 75.
figure 75. example of adjusting fence 45˚ out-
ward.
3.
loosen the jam nut on the 45˚ outward fence
stop bolt (see figure 76).
Jam nut
figure 76. 45˚ outward fence stop bolt.
4.
adjust the 45˚ outward fence stop bolt until it
makes contact with the back of the fence.
5.
retighten the jam nut loosened in Step 3.
-42-
Fence stop Bolt
Adjusting Gibs
the table gibs eliminate excessive play in the
table movement, and control how easy the tables
move up and down.
Tools Needed
Wrench 10mm ................................................... 1
hex Wrench 3mm .............................................. 1
To adjust the table gibs:
1.
using a 10mm wrench, loosen the three
infeed table gib nuts on the back of the jointer
base (see figure 77).
gib nuts and set screws
figure 77. table gib nuts and set screw loca-
tions.
2.
oil the gibs if needed (see page 34).
3.
using a 3mm hex wrench, evenly tighten the
gib set screws a small amount, then check
the table by moving it up and down. adjust
the set screws as needed until the friction
of the table movement is balanced between
minimal play and ease of movement.
Note: Tighter gibs reduce play but make it
harder to adjust the tables.
4.
repeat Steps 1-3 with the outfeed table, and
oil the outfeed table leadscrew, if needed.
5.
set the outfeed table height as described in
Setting Outfeed Table height on page 22.
Model G0654 (Mfg. Since 9/07)
Qty
Advertisement
Table of Contents
