Access The Web Configuration Menu - Grandstream Networks HT503 User Manual

ACCESS THE WEB CONFIGURATION MENU

The HT503 HTML configuration page can be accessed via LAN or WAN ports.
•
From the LAN port:
1. Directly connect a computer to the LAN port
2. Open a command window on the computer
3. Type in "ipconfig /release", the IP address etc becomes 0
4. Type in "ipconfig /renew", the computer gets an IP address in 192.168.2.x segment by
default
5. Open a web browser, type in the default IP address of the LAN port. http://192.168.2.1. You
will see the log in page of the device.
•
From the WAN port:
1. Follow table 4 to find the WAN side IP address.
2. Open a web browser, type in the WAN side IP address – for example:
http://HT503-WAN-IP-Address
Note:
•
WAN side HTTP access is disabled by default for security reason. You can enable HTTP access
on the configuration page by setting "WAN side HTTP access" to be YES.
•
Initial access to the configuration pages is always from the LAN port. The instructions are listed
above.
The IVR announces 12 digits IP address, you need to strip out the leading "0" in the IP address.
•
For ex. IP address: 192.168.001.014, you need to type in http://192.168.1.14 in the web browser.
Once the HTTP request is entered and sent from a web browser, the user will see a log-in screen. There
are two default passwords for the login page:
User Level:
End User Level
Administrator Level
The password is case sensitive with maximum length of 25 characters. The factory default password for
FIRMWARE VERSION 1.0.9.1
Password: Web pages allowed:
123 Only Status and Basic Settings
admin Browse all pages
HT503 USER MANUAL
Page 28 of 59