Voip-To-Pstn Calls - Grandstream Networks HT503 User Manual

VOIP-TO-PSTN CALLS

This function is available using the FXO port. The FXO port functions as a bridge between the Internet
and PSTN. The user can remotely use a PSTN line to initiate a call.
T M V IP- -PSTN C
O AKE A O TO
1. Dial the FXO SIP account phone number to establish the VoIP session. The caller will hear the
ring back tone once. Then the caller hears either a special continuous tone or a dial tone. The
special continuous tone is played if the pin code is configured, otherwise, the caller will hear a dial
tone.
2. Enter the PIN code (if configured under the BASIC configuration page). The caller will hear a dial
tone and be connected to the PSTN line if the PIN code is valid. If the PIN code is invalid, the
continuous tone is played to prompt caller to enter the PIN code again. The user may try up to 3
times to enter a correct PIN code. After three (3) tries, the HT503 hangs up.
3. After the caller hears a dial tone from PSTN line, the caller can place the next call.
4. The user can hit the # key to identify the end of the pin code or wait 4 seconds for a new dial tone
and then dialing the PSTN number.
Note:

Users can choose whether or not to apply password protection for VoIP-to-PSTN calls. A PIN (Pin
for PSTN calls) consists of up to 8 numeric digits and can be configured using the BASIC
SETTINGS of the web configuration page. By default, there is no password protection. (I.e. there
is no authentication required for callers on the use of PSTN line through HT503).

When a PIN is configured for VOIP-to-PSTN call flow, the VoIP device that calls into the HT503
FXO account needs to configure RFC2833 or SIP Info for DTMF digit transmission.

The special continuous tone is the prompt to enter a valid PIN code. If a caller doesn't enter a
valid PIN, the HT503 times out after 10 seconds. Users may press the "#" key to indicate the end
of an input or wait 4 seconds.

On the web configuration page, if the "Forward to PSTN" is configured, the second stage dialing
format is eliminated, so after dialing into the FXO SIP account number, the PSTN number will be
called automatically
FIRMWARE VERSION 1.0.9.1
:
ALL
HT503 USER MANUAL
Page 21 of 59