Saving The Configuration Changes; Rebooting From Remote; Firmware Version 1.0.9.1 - Grandstream Networks HT503 User Manual

PSTN Ring Thru Delay
(sec)
DTMF Digit Length (ms)
DTMF Dial Pause (ms)
First Digit Timeout (sec)
Inter Digit Timeout
Wait for Dial Tone
Stage Method (1/2)

SAVING THE CONFIGURATION CHANGES

After user makes a change to the configuration, press the "Update" button in the Configuration Menu. The
web browser will then display a message window to confirm saved changes, press "Apply" button to
confirm.
Grandstream recommends reboot or power cycle the IP phone after saving changes

REBOOTING FROM REMOTE

Press the "Reboot" button at the bottom of the configuration menu to reboot the phone remotely. The web
browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in
again.

FIRMWARE VERSION 1.0.9.1

If the PSTN Ring Thru Delay is set to Yes, all incoming PSTN calls through FXO will
ring the phone connected to the FXS port, after this delay or after caller id is detected
(whichever comes first).
Digit length and Dial Pause are port digit dialing configurations; FXO needs to dial out
digits for VOIP to PSTN 1 stage calls, and unconditional call forward to PSTN, and
route to PSTN. Digit Length is the play time for each digit.
Note: In order to receive the caller ID information, the delay should be set to a value
larger than the delay required to complete the PSTN caller ID delivery.
Dial pause is the time between 2 digits for the same scenario as explained above.
Used for PSTN to VoIP calls. PSTN users need to enter the FIRST digit within the first
digit timeout period. Otherwise the call will be dropped.
When dialing from the PSTN to VoIP, subsequent digits have to be input within the
period of inter-digit timeout. Otherwise the dial plan thinks it is the end of the digit input.
Wait for Dial tone is used for one stage VoIP to PSTN calls. If set to Yes, the device will
first obtain a PSTN line and a dial tone from a central office. After obtaining the dial
tone, the digits dialed will be sent to the central office.
This configuration is applicable for VoIP to PSTN calls and indicates one or two stage
dialing methods.
HT503 USER MANUAL
Page 53 of 59