Call Hold; Call Waiting - Grandstream Networks HT503 User Manual

Using Star Code
1. Pick up the analog phone then dial "*47"
2. Enter the target IP address using same format as above.
Note: NO dial tone will be played between step 1 and 2.
Destination ports can be specified by using "*" (encoding for ":") followed by the port number.
Examples:
a) If the target IP address is 192.168.0.160, the dialing convention is
*47 or Voice Prompt with option 47, then 192*168*0*160.
followed by pressing the "#" key if it is configured as a send key or wait 4 seconds. In this case,
the default destination port 5060 is used if no port is specified.
b) If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:
*47 or Voice Prompt with option 47, then 192*168*0*160*5062 followed by pressing the "#" key
if it is configured as a send key or wait for 4 seconds.
NOTE: When completing direct IP call, the "Use Random Port" should set to "NO". You can not make
direct IP calls between FXS1 to FXS2 since they are using same IP.

CALL HOLD

This function is applicable on the FXS port for VoIP calls only. While in conversation, pressing the "flash"
button on the connected phone (if the phone has that button) places the remote end on hold. Pressing the
"flash" button again releases the previously held party and the conversation can resume. If no "flash"
button is available, then on-off hook quickly (hook flash) will do the same thing. You may lose the call if
'hook flash' is not quick enough.

CALL WAITING

This function is applicable on FXS port for VoIP calls only. If the call waiting feature is enabled, the user
will hear a special stutter tone if there is another call on the line. Press the flash button to place the
current party on hold and switch to the other call. Pressing the flash button toggles between two active
calls. The HT503 also provides CWCID (call waiting caller ID) information which includes caller ID
information in addition to the special stutter tone. The analog phone must support this feature for it to
work on the HT503. Both call waiting functions (call waiting and CWCID) are activated and deactivated
from the configuration pages menu.
FIRMWARE VERSION 1.0.9.1
HT503 USER MANUAL
Page 18 of 59