Port Forwarding - Q-See QR4714 User Manual

Caution: a dynamic address (IP numbers) can change from time to time
depending upon your service provider. If the remote monitoring stops
working at some point, the IP address may have changed. To check it, go
to a website, such as www.myipaddress.com, from a computer attached
to the same router as the DVR to find the new IP address (Image 17).
Then repeat steps 1 and 2.
IMAge 16
To avoid a change in IP Address by your Internet Service Provider ask your service provider for
a static IP address or use a dynamic domain name service to get a domain name that can be
linked to your dynamic address. You can register for a domain name (a name rather than an
IP number), user name, and password through our company's www.myq-see.com website.
Repeat steps 1 and 2 using the new domain name, username and password. This DVR also
supports the DDNS service provided by dyndns. For more information on how to use these
services from the myq-see.com or www.dyndns.com websites.

port Forwarding

To access the DVR from a remote computer over the internet port 80 and port 9000 on the
router the DVR is attached to must be set to forward to the IP address. Instructions for most
popular routers can be found at the Port Forward website.
To find the instructions for your specific router:
1. Go to www.portforward.com
2. Click on the orange "ROUTERS" link in the second paragraph as shown in
3. On the list of manufacturers, locate the brand and model number of your router and
select NEXT
4. Click the orange "DEFAULT GUIDE" link (
Caution: a dynamic address (IP numbers) can change from time
to time depending upon your service provider. If the remote
monitoring stops working at some point, the IP address may have
changed. To check it, go to a website, such as www.myipaddress.
com, from a computer attached to the same router as the DVR to
find the new IP address (Image 17). Then repeat steps 1 and 2.
WaRning!
IMAge 19
)
IMAge 17
IMAge 18