Pppoe; Port Forwarding; Determining The Ip Address Of The Dvr - Q-See QT528 User Manual

PPPOE

If you are going to attach the DVR directly to a DSL or cable modem instead of to a router
then select the PPPOE option in the Network options. Before you proceed, you will need to
contact your ISP to obtain your User Name and Password.
STEP 1. Select the Setup icon in the
Main Menu (Red Box in Picture
7-10)
STEP 2. Select the Network icon (Red
box in Picture 7-11)
STEP 3. Check the box next to PPPoE
Red Box in Picture 7-12)
STEP 4. Enter the User Name and
Password obtained from your ISP in
the fields below PPPoE
STEP 5. Click the Test button to verify
your settings.
STEP 6. After receiving the OK message
in the lower left of your screen, click
on the Apply button to save your
settings before exiting.
48
PICTURE 7-10
PICTURE 7-11
PICTURE 7-12

7.3 PORT FORWARDING

Port Forwarding allows computers and devices outside of your network to communicate
with the DVR. You will need to forward ports 80 and 6036 from the attached router to the
IP address of the DVR. Your router must be powered up and attached to the DVR before
proceeding.
NOTE! The DVR and PC must be connected to the same router.
Things you will need to know :
1. The make and model of the router.
2. If you changed the default router login, then you will need to know the user name and
password for that router.
3. The IP address for the router.
4. You will be forwarding ports 80 and 6036.

DETERMINING THE IP ADDRESS OF THE DVR

To find out the IP of DVR for QT4 and QT52 series DVRs do the following:
STEP 1. Using the mouse, right-click
anywhere on the screen to bring up
the Control Bar. Click on the Menu
icon on the far left of the bar to open
the Main Menu.
STEP 2. Click on the Setup icon (Red
box in Picture 7-14) in the Main
Menu.
PICTURE 7-13
PICTURE 7-14
49