Fluke 805 User Manual page 25

Fluke supports, but does not provide, external
sensors.
Figure 3. External Sensor Connection
High frequency measurement (Crest Factor+) and
Temperature measurement automatically turn off
when an external sensor is connected to the
Meter.
To connect:
1. Open the connector cover and push the external
sensor into position.
Note
Note
After you connect the external sensor, a pop-up
message opens on the Meter display and then
opens the Enter Sensitivity menu.
gqi05.eps
The sensitivity must be set in mV/g units.
2. Push  and  to select a character in the menu.
3. Push  to input the character into the field.
4. Repeat steps 2 and 3 for additional characters.
5. Push  to store the value in the Meter and exit
the menu.
6. Push  to start data collection.
The Meter automatically detects when you disconnect the
external sensor and is set to measure with the internal
sensor.
Vibration Meter
How to Operate
Note
gqi14.eps
15