Table of Contents
Advertisement
Factory Settings
Table 3-4 lists the setup functions and their respective factory set values.
Setup Item
Volume
Brightness
Beeper
Calibration password
Time
Date
Voltage calibrator
Compensator
Calibrator GND
High resistance source GND
R multiplier input
Low resistance source GND
Loop impedance correction
Loop impedance MAN value
Loop impedance SCAN value
Line impedance correction
Line impedance MAN value
Line impedance SCAN value
Substitute LC Rout
RCD I level
RCD serial resistance
Meter GND
Error Messages
Error messages appear in the Calibrator's display when either an invalid operation is
attempted or some internal check reveals a problem with the Calibrator. Some conditions
that generate error messages are:
Invalid front-panel operations that try to force a prohibited mode, such as setting an
out-of-range value.
Internal faults such as a communications error between functional parts of the
Calibrator.
Invalid commands to the communications interface.
Table 3-4. Factory Settings
15
6
ON
0
GMT
GMT
Yes/No
Yes/No
ON
ON
0 MN
ON
OFF
0.000 N
0.000 N
OFF
0.000 N
0.000 N
2.000 N
90 %
R0
OFF
Front-Panel Operation
Factory Settings
Factory Set Value
3
3-15
Advertisement
Table of Contents
