Vrrp Operation; Simple Vrrp Network Configuration - Extreme Networks ExtremeWare XOS Guide Manual

• VRRP and Spanning Tree can be simultaneously enabled on the same switch.

VRRP Operation

This section describes two VRRP network configuration:
• A simple VRRP network
• A fully-redundant VRRP network

Simple VRRP Network Configuration

Figure 27 shows a simple VRRP network.
Figure 27: Simple VRRP network
Switch A
Switch A = Master
VRID = 1
Virtual router IP address = 192.168.1.3
MAC address = 00-00-5E-00-01-01
Priority = 255
In Figure 27, a virtual router is configured on Switch A and Switch B using these parameters:
• VRID is 1.
• MAC address is 00-00-5E-00-01-01.
• IP address is 192.168.1.3.
Switch A is configured with a priority of 255. This priority indicates that it is the master router. Switch B
is configured with a priority of 100. This indicates that it is a backup router.
The master router is responsible for forwarding packets sent to the virtual router. When the VRRP
network becomes active, the master router broadcasts an ARP request that contains the virtual router
MAC address (in this case, 00-00-5E-00-01-01) for each IP address associated with the virtual router.
Hosts on the network use the virtual router MAC address when they send traffic to the default gateway.
The virtual router IP address is configured to be the real interface address of the IP address owner. The
IP address owner is usually the master router. The virtual router IP address is also configured on each
backup router. However, in the case of the backup router, this IP address is not associated with a
physical interface. Each physical interface on each backup router must have a unique IP address. The
virtual router IP address is also used as the default gateway address for each host on the network.
ExtremeWare XOS 10.1 Concepts Guide
192.168.1.3
Default Gateway = 192.168.1.3
Switch B
Switch B = Backup
VRID = 1
Virtual router IP address = 192.168.1.3
MAC address = 00-00-5E-00-01-01
Priority = 100
192.168.1.5
VRRP Operation
EX_068
169