Displaying Stp Settings - Extreme Networks ExtremeWare XOS Guide Manual

Displaying STP Settings

In this example, the commands configure switch A in STPD1 for rapid reconvergence. Use the same
commands to configure each switch and STPD in the network.
create stpd stpd1
configure stpd stpd1 mode dot1w
create vlan sales
create vlan personnel
create vlan marketing
configure vlan sales tag 100
configure vlan personnel tag 200
configure vlan marketing tag 300
configure vlan sales add ports 1:1,2:1 tagged
configure vlan personnel add ports 1:1,2:1 tagged
configure vlan marketing add ports 1:1,2:1 tagged
configure stpd stpd1 add vlan sales ports all
configure stpd stpd1 add vlan personnel ports all
configure stpd stpd1 add vlan marketing ports all
configure stpd stpd1 ports link-type point-to-point 1:1,2:1
configure stpd stpd1 tag 100
enable stpd stpd1
Displaying STP Settings
To display STP settings, use the following command:
show stpd {<stpd_name> | detail}
This command displays the following information:
• STPD name
• STPD state
• STPD mode of operation
• Rapid Root Failover
• Tag
• Ports
• Active VLANs
• Bridge Priority
• Bridge ID
• Designated root
• STPD configuration information
ExtremeWare XOS 10.1 Concepts Guide 163