All Models - Troy-Bilt 34020C Owner's/Operator's Manual

FEATURES ANDCONTROLS ON ALLMODELS
Handlebar Position
AdjustmentKnob
EngineRecoil Starter Rope
(Handle BehindPanel)
Cuttin_
Height
Adjustment
LockingSquareBail Pin
CoverInterlockSwitch
Figure 3-1: Features and controls on all models (Model 34326 shown).
Engine Recoil Starter
The Engine Recoil Starter Rope is
located as shown in Figure 3-1.
Operating the recoil starter is fully
described in the Operation
Section.
Upper Handlebar Position
Adjustment Knobs
The location of the upper handle-
bar position adjustment knobs is
shown in Figure 3-1. Adjusting
the handlebars is described in the
Assembly and Operation Sections.
NOTE: On some models the ad-
justment knobs are located on the
inside of the handlebars.
Cutting Height Adjustment
Handle
The cutting height is changed by
turning the handle (shown in
Figure 3-1). Adjusting the cutting
height is fully described in the
Operation Section.
Locking Square Bail Pins
The locking square bail pins
(shown in Figure 3-1 ) are used to
release the lower handlebars so that
the lower handlebars can be folded
forward. Operation of these pins is
described on Page 7. The upper
handlebars can then be folded
downward over the lower handle-
bars for purposes of transportation
or storage. This procedure is
described in the Maintenance
Section.
Cover Interlock Switch
This mechanism (shown in Figure
3-1) prevents the engine from
starting or operating unless either
the discharge cover or the optional
grass catcher is properly installed
on the mower.
10