Advertisement
Quick Links
2.10.23
Calibration of the Throttle Position Sensor (TPS)
Generation 2 VCM (625-08995)
Model(s) Included:
Mustang 42E XP (34ABB2CSB66)
INDEX:
GEN 2 Vehicle Control Module (625-08995)
Buttons: Page 1.
Pre-Calibration Steps: Page 2.
Calibration Steps: Page 3-4.
DOME SWITCH
769-26782/00
Instruction Sheet
1 of 4
Advertisement
Related Manuals for Troy-Bilt Mustang 42E XP
Summary of Contents for Troy-Bilt Mustang 42E XP
- Page 1 2.10.23 Calibration of the Throttle Position Sensor (TPS) Generation 2 VCM (625-08995) Model(s) Included: Mustang 42E XP (34ABB2CSB66) INDEX: GEN 2 Vehicle Control Module (625-08995) Buttons: Page 1. Pre-Calibration Steps: Page 2. Calibration Steps: Page 3-4. DOME SWITCH 769-26782/00 Instruction Sheet...
- Page 2 Pre Calibration Steps: 1. Park the mower on a flat level surface. Chock the rear wheels. 2. Equal air pressure and tire size is important on zero turn mowers and is especially important for the electrically powered drive motors. Check and maintain both rear tires at 10 psi and the front tires at 20 psi. 3.
- Page 3 IMPORTANT: The brake must be released. DO NOT touch the brake pedal during any part of the calibration procedure. NOTE: If during the calibration procedure an error code shows up on the screen; remove the key, start the calibration procedure over at Step 1. Calibration Steps: 10.
- Page 4 24. Place the right lap bar in the “OUTWARD” position 15. For the right side lap bar calibration, proceed as and press the START button. follows. 16. Place both lap bars in the “OUTWARD” position. 17. Simultaneously press and hold the PTO and DOME 25.