Donotuse/Store Thecamera In The Following Places; Onoperating Temperatures; Onmoisture Condensation - Sony SLT-A35 Instruction Manual

Precautions
Donotuse/store thecamera in
the following places
• In an extremely hot, dry or humid
place
In places such as in a car parked in
the sun, the camera body may
become deformed and this may
cause a malfunction.
• Storing under direct sunlight or
near a heater
The camera body may become
discolored or detbrmed, and this
may cause a malfunction.
• In a location subject to rocking
vibration
• Near strong magnetic place
• In sandy or dusty places
Be carefid not to let sand or dust get
into the camera. This may cause the
camera to malfunction, and in some
cases this malfunction cannot be
repaired.
• Humid places
These may mold on a lens.
Onstoring
Be sure to attach the front lens cap
or body cap when not using the
camera. When attaching the body
cap, remove all the dust from the
cap before placing it on the camera.
When you purchase the DT 18-
55ram F3.5-5.6 SAM Lens Kit,
purchase the Rear Lens Cap ALC-
R55 also.
Onoperating temperatures
Your camera is designed t_r use
under the temperatures between 0 and
40°C (32 and 104°F). Shooting in
extremely cold or hot places that
exceed this range is not
recommended.
Onmoisture condensation
If the camera is brought directly from
a cold to a warm location, moisture
may condense inside or outside the
camera. This moisture condensation
may cause a malt'unction of the
canlera.
How to prevent moisture
condensation
When bringing the camera from a
cokt place to a warm place, seal the
camera in a plastic bag and allow it to
adapt to conditions at the new
location over about an hour.
If moisture condensation occurs
Turn off the camera and wait about an
hour for the moisture to evaporate.
Note that if you attempt to shoot with
moisture remaining inside the lens,
you will be unable to record clear
images.
g
191