Sony DCR-TRV40 Operating Instructions Manual page 3

IMPORTANT NOTE
To comply with FCC RF exposure compliance
requirements, the fbllowing antenna
installation and device operating
configurations must be satisfied: the antenna
has been installed by tile
manufhcturer and no changes can be made.
"Memory Stick"
This device con-li)lies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause tmdesired
operation.
"Memory Stick"
This Class B digital apparatus complies with
Canadian ICES 003.
The term "IC:" before tile radio certification
number only signifies that Industry Canada
technical specifications were met.
CAUTION
You are cautioned that any changes oi"
modifications not expressly approved in this
manual could void your authority to operate
this eqnipment.
Note:
This eqnipn-lent has been tested and found to
comply with tile limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmfhl
interference in a residential installation. This
eqnipment generates, uses, and can radiate
radio flequency energy and, if not installed
and used in accordance with the instructions,
may cause harmfl/1 interference to radio
conlnlunications. Hovv'ever, there is i1o
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmfhl interference to radio or
television reception, which can be determined
by turning tile eqnii)ment off and on, tile user
is encouraged to try to correct tile interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase tile separation between tile
equipment and receiver.
Connect the equipment into an outlet on a
circuit diffbrent Dora that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician fbr help.
Tile supplied interfime cable must be used with
the eqoipment in order to comply with the
limits for a digital device ptnsuant to Subpart
B of Part 15 of FCC Rules.
3