Card Offset Adjustments; Adjusting The Card Offset For The Print Station; Adjusting The Rp3 Card Offset Location - FARGO electronics S000256 User Manual

RESTRICTED USE ONLY

Card Offset Adjustments

Adjusting the Card Offset for the Print Station

When the factory calibrates the Printer, the output print on the card is centered horizontally.
Caution: For ribbon breakage between the yellow and the clear panel of the
ribbon, or a card jam just as the card is being presented to the Printhead, adjust the card
offset RP3 potentiometer (as needed). See below.

Adjusting the RP3 Card Offset Location

Step Procedure
1 To adjust the RP3 potentiometer counter-clockwise in 1/8
running the standard self test, feed more of the card's leading edge beneath the
Printhead as the card is printed. See the Performing the Standard Self Test
procedure on page 57.
2 To center the print more precisely on the card, such as printing full edge-to-edge,
use the Printer's software Driver's calibration controls. See the Selecting the
Print Edge-to-Edge checkbox procedure on page 96.
Persona® C25 Card Printer User Guide (Rev. 4.0)
DARKNESS Rp7
Rp1 OFFSET MAG
Tp3
Tp5
COLOR
FARGO Electronics, Inc.
th
turn increments while
OFFSET PRN
Rp6
RP3
OFFSET LAM
68