Installing The Full Driver Package On Boot Luns - Dell Brocade Adapters Installation And Reference Manual

4
Boot over SAN
10. Press Enter.
11. If the system prompts you to update another driver, select BACK, then press Enter.
12. When prompted to insert the SLES 11 product CD #1, insert the CD into the drive and select
13. Continue responding to on-screen instructions and refer to your system documentation as

Installing the full driver package on boot LUNs

The preceding procedures for each operating system under
installation on boot LUNs"
Command Line Utilities. To install the full driver package with adapter agent and all BCU
commands, including bfa_supportsave, perform these additional steps.
NOTE
For information available driver packages and operating system support for drivers, refer to
"Software installation and driver packages"
page 40.
1. Compare the version of the full driver package that you wish to install with the version of the
2. Install the full driver package using steps for your operating system under
3. If the version of the driver installed on the boot LUN and the driver you are installing do not
162
The driver loads to the system.
If the driver update was successful, a "Driver Update OK" or similar message displays:
OK.
necessary to format and complete installation on the target boot LUN.
After SLES installs on the remote LUN, the system should automatically reboot from the LUN.
on page 148, do not install the HCM Agent and the full range of Brocade
driver already installed on the boot LUN. There are a variety of methods to determine the driver
version installed on your operating system. Refer to
page 103 for more information.
If the versions do not match, you will perform additional steps to initialize the new package on
your system.
Adapter Software Installer"
•
If the driver that you install and the driver already installed on the LUN match, perform
steps as normal to complete installation. You will be able to use the additional utilities and
HCM Agent installed with the full package.
For Linux systems, install the latest version of brocade_driver_linux_<version>.tar.gz using
instructions under "Driver installation and removal on Linux systems"
install all package utilities without updating the driver. You do not need to reboot the
system.
•
If the driver that you install and the driver already installed on the LUN do not match, go on
to step 3.
match, perform these additional steps for your operating system:
Windows
Reboot the system to initialize the new driver.
on page 43 and
"Confirming driver package installation"
on page 68
Brocade Adapters Installation and Reference Manual
"Operating system and driver
"Operating system support"
"Using the Brocade
on page 95. This will
on
on
53-1002144-01