Connecting An Adapter To A Switch Or Direct-Attached; Storage - Dell Brocade Adapters Installation And Reference Manual

2
Stand-up adapters
1
2
3
4
5
FIGURE 9
10. Secure the adapter's mounting bracket to the case using the method required for your case.
11. If you removed transceivers in step
12. Replace the system's case or cover and tighten all screws.
Connecting an adapter to a switch or direct-attached storage
Use multimode fiber optic cable or twinaxial copper cable (Fabric Adapters with ports configured in
CNA mode and CNAs only) with appropriate connectors when connecting the adapter to the switch.
Use multimode fiber optic cable when connecting an HBA or Fabric Adapter port configured in HBA
mode to a switch or direct-attached storage. Refer to
for cable specifications.
58
1
2
5
4
Mounting screw
Top edge of adapter (press down into slot)
PCI X8 slot
Edge of host board
SFP receivers
Installing adapter in system chassis
Note that in some systems, the bracket may secure to the case with a screw.
"Removing and installing SFP transceivers"
2
3
step 7, make sure to install adapter receivers. Refer to
on page 59 for procedures.
"Cabling (stand-up adapters)"
Brocade Adapters Installation and Reference Manual
on page 183
53-1002144-01