Operating System And Driver Installation On Boot Luns - Dell Brocade Adapters Installation And Reference Manual

4
Boot over SAN
6. Execute a reset EFI shell command to reinitialize the system.
7.
8. Refer to procedures for your system's Boot Configuration menu to verify that your host is
9. Refer to instructions under

Operating system and driver installation on boot LUNs

Use the procedures in this section to install the host operating system and adapter drivers on an
unformatted disk that you that you configured as a bootable device when setting up the adapter
BIOS or UEFI on the host system. Instructions are provided for the following:
•
•
•
•
•
•
•
For information on operating system support for drivers, refer to
page 49 and
Before installing the operating system and adapter drivers, be sure you have bound the PWWN of
the appropriate adapter port to the designated boot LUN and have configured the BIOS or UEFI on
your host system for booting over SAN. Refer to
"Configuring BIOS using the Brocade configuration utility"
page 146 for instructions.
NOTE
The following procedures load the operating system, adapter drivers, and utilities to the designated
boot LUN to allow adapter operation and booting your host system from the LUN. However, the HCM
Agent and full range of Brocade Command Line Utilities, such as bfa_supportsave, are not installed.
To install the complete driver package with HCM Agent and full-range of utilities, refer to
the full driver package on boot LUNs"
148
NOTE
You could configure the other adapter port using the drvcfg -s command by keeping the driver
handle the same and using the other controller handle (drvcfg -s 25 28).
When the system restarts, all available Fibre Channel devices display in map output as the EFI
Shell initializes. SAN drives display with "Fibre" as part of the device name.
Find the LUN that you have targeted for boot over SAN in the system's map output.
Note that you can also enter the following EFI shell command to list all storage targets and
LUNs visible to the adapter port. SAN drives display with "Fibre" as part of the device name.
dh -d [controller handle]
configured to automatically boot from the target remote LUN.
page 148 to install the host's operating system and adapter driver to the LUN
"Installing Windows Server 2003 and the driver"
"Installing Windows Server 2008 and the driver"
"Installing Linux RHEL 4.x or 5.x and the driver"
"Installing Linux (SLES 10 and later) and the driver"
"Installing Solaris and the driver"
"Installing VMware and the driver"
"Installation on systems supporting UEFI"
"Operating system support"
"Operating system and driver installation on boot LUNs"
on page 40.
"Configuring boot over SAN"
on page 162 after completing the following steps.
Brocade Adapters Installation and Reference Manual
"Boot installation packages"
on page 131,
on page 136, and "Configuring UEFI"
on
on
on
"Installing
53-1002144-01