Port Access Control; Authenticator State - D-Link xStack DGS-3324SRi User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual

Port Access Control

The following screens are used to monitor 802.1x statistics of the Switch, on a per port basis. To view the Port Access
Control screens, open the monitoring folder and click the Port Access Control folder. There are six screens to monitor.

Authenticator State

The following section describes the 802.1X Status on the Switch. To view the Authenticator State, click Monitoring >
Port Access Control > Authenticator State.
NOTE: The Authenticator State, Authenticator Statistics, Authenticator
Session Statistics and Authenticator Diagnostics windows in this
section cannot be viewed on the xStack DGS/DXS-3300 Switch Series
unless 802.1x is enabled by port or by MAC address. To enable 802.1x,
go to the Switch 802.1x entry in the Advanced Settings window under
the Configuration menu.
Figure 9- 18. Authenticator State window – Port-based 802.1x
270