Dhcp/Bootp Relay Interface Settings - D-Link xStack DGS-3324SRi User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual

DHCP/BOOTP Relay Interface Settings

The DHCP/ BOOTP Relay Interface Settings allow the user to set up a server, by IP address, for relaying DHCP/
BOOTP information to the Switch. The user may enter a previously configured IP interface on the Switch that will be
connected directly to the DHCP/BOOTP server using the following window. Properly configured settings will be displayed
in the BOOTP Relay Table at the bottom of the following window, once the user clicks the Add button under the Apply
heading. The user may add up to four server IPs per IP interface on the Switch. Entries may be deleted by clicking it's
corresponding .
Figure 6- 152. DHCP/BOOTP Relay Interface Settings and DHCP/BOOTP Relay Interface Table window
The following parameters may be configured or viewed.
Parameter
Interface
Server IP
Description
The IP interface on the Switch that will be connected directly to the Server.
Enter the IP address of the DHCP/BOOTP server. Up to four server IPs can be
configured per IP Interface
188