Ip Multicast Routing Protocol; Igmp; Igmp Versions 1 And 2 - D-Link xStack DGS-3324SRi User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual

IP Multicast Routing Protocol

The functions supporting IP multicasting are added under the IP Multicast Routing Protocol folder, from the Layer 3 IP
Networking folder.
IGMP, DVMRP, and PIM-DM can be enabled or disabled on the Switch without changing the individual protocol's
configuration.

IGMP

Computers and network devices that want to receive multicast transmissions need to inform nearby routers that they will
become members of a multicast group. The Internet Group Management Protocol (IGMP) is used to communicate this
information. IGMP is also used to periodically check the multicast group for members that are no longer active.
In the case where there is more than one multicast router on a subnetwork, one router is elected as the 'querier'. This router
then keeps track of the membership of the multicast groups that have active members. The information received from
IGMP is then used to determine if multicast packets should be forwarded to a given subnetwork or not. The router can
check, using IGMP, to see if there is at least one member of a multicast group on a given subnetwork. If there are no
members on a subnetwork, packets will not be forwarded to that subnetwork.

IGMP Versions 1 and 2

Multicast groups allow members to join or leave at any time. IGMP provides the method for members and multicast
routers to communicate when joining or leaving a multicast group.
IGMP version 1 is defined in RFC 1112. It has a fixed packet size and no optional data.
The format of an IGMP packet is shown below:
The IGMP Type codes are shown below:
Type
0x11
0x11
0x16
0x17
0x12
IGMP packets enable multicast routers to keep track of the membership of multicast groups, on their respective
subnetworks. The following outlines what is communicated between a multicast router and a multicast group member
using IGMP.
A host sends an IGMP "report" to join a group
A host will never send a report when it wants to leave a group (for version 1).
A host will send a "leave" report when it wants to leave a group (for version 2).
Figure 6- 161. IGMP Message Format
Meaning
Membership Query (if Group Address is 0.0.0.0)
Specific Group Membership Query (if Group Address is Present)
Membership Report (version 2)
Leave a Group (version 2)
Membership Report (version 1)
Table 6- 7. IGMP Type Codes
197