The Remote; To Control A Dvd Player Or Laserdisc Player; To Control An Rca Audio Device - ProScan PS61670 User Manual

PROGRAMMING THE REMOTE TO CONTROL
A DVD PLAYER OR LASERDISC PLAYER
The remote's DVD-VCR button is preprogrammed to control the
primary functions of a Proscan, GE, or RCA DVD player. If you would
like this button to control a device other than a DVD player, you may
program the remote to control a laserdisc player or VCR. To program
the DVDoVCR button to control a device, use the DVD player or
laserdisc player codes at the right or the VCR codes on the previous
page.
1. Turn on the DVD player, laserdisc player or VCR.
2. Look up your brand and its code number(s) on the code lists.
3. Press and hold the DVDoVCR2 button on the remote.
4.
5.
6.
Enter the two-digit code from the code list.
Release the DVD.VCR2 button and press POWER or another
button to see if the device responds to the remote commands.
Repeat these steps using the next code listed for your brand, until
the device responds to the remote commands.
[
DVD Player Codes
GE ............................................... 78
ProScan....................................... 78
RCA ............................................. 78
Laserdisc Player Codes
Pioneer ................................... 33,37
ProScan .................................. 33,37
RCA ........................................ 33,37
PROGRAMMING THE REMOTE TO CONTROL
AN RCA
AUDIO DEVICE:
Your remote controls only RCA audio equipment such as an audio
receiver or.amplifier--it does not control other brands of audio
equipment. Also, the remote may need to be programmed for your
equipment. This remote may not operate all models of the brands that
are _hown at right. Use the codes below or on the sheet packed in
with your remote.
I. Turn on the component to be programmed.
2. Look up your brand and its code number(s) on the code list.
3. Press and hold the AUDIO button.
4.
5.
Enter the two-digit code from the code list.
Release the AUDIO button and press POWER or CH A (channel
up) or CH v (channel down) to see if the audio device responds to
the remote commands.
6, Repeat these stepsusing the next code listed for your brand until
the audio device respondsto the remote commands.
Audio Codes
RCA/Dimensia
AM/FM ........................................ 03
CD .............................................. 07
Tape ............................................ 06
Phono .......................................... 0S
Aux ............................................. 04
32