ProForm 650 CardioCrossTrainer User Manual page 8

8. Apply a small amount of grease to the axle on the left
Disc Crossbar(16). Slide a Spdng Spacer (63) onto the
axle; make sure that (he Spring Spacer ta turned so
the fiat aide Is facing the elliptical oroaatralner.
Next, slidethe Left Rear Spdng Bracket(12) on the left
Pedal Spdng (11) onto the axle. Slide a SpringBracket
Washer (35) onto an M10 x 27ram Patch Screw (40),
and tightenthe Patch Screw intothe axle.
Next, hold the lower end of the left Handlebar Leg (5)
inside of the Front Spdng Bracket (65) on the left Pedal
Spdng (11). Apply grease to an M10 BoltSet (25).
Attach the Handlebar Leg to the Front Spdng Bracket
with the Bolt Set. Do not overtlghtan the Bolt Sat;
the Handlebar Leg must pivot freely.
Attach the dght Pedal Spdng (cot shown)to the right
side of the ellipticalcrosstralnerin the same way.
Refer to step 5. Tighten the M10 x 74ram Bolts(7) in
the Updght (2).
Refer to step 6. Tighten the M8 x 45mm ButtonBolts
(50) in the Handlebar Legs (5).
7" 16
40 35
65
Grease
11
9. Make sure that all parts of the elliptical crosstrainer are propedy tightened. Note: Some hardware may
be left over after assembly is completed.To protectthe floor _ carpet from damage, place a mat under the
ellipticalcrosstralner.
8