Programming The Remote To Operate Other Components; Find Out If You Need To Program The Remote; How To Program The Remote - RCA F26317YX51AA5 User Manual

Using Re @ e C@n r@M
_VD VCR2 AU× SAT.C_SL[
& &oi,, A
¢_ +
You'll use these buttons when you program the
remote to operate another component.
The remote may not operate all models of
all brands.
Programming the Remote to Operate
Other Components
The universal remote control can be progranlmed to operate nlost brands
of remote controllable VCRs, satellite receivers and cable boxes. "File
remote is already programmed to operate most RCA, GE and PROSCAN
TVs, VCRs, DVD players, laserdisc players and satellile receivers.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed,
turn a component ON, such as a VCR, point the remote at the VCR, and
press the VCR1 button. Then press ON-OFF or channel kip or channel
down to see if the VCR responds to tile remote commands. If not, tile
r(,n:ot(,ne('ds
to be progra:nmt, d_
How to Program the Remote
There an. two ways to progranl tile renlote
control:
automatic cod(.
search and direct entry. Instructions fk_r both ways follow.
rip
To stop the automatic code search without
programming any components, press and hold CLEAR
until the light on the remote turns of-[.
Using Automatic Code Search
1. Turn on the, component you want the, remote to operate (VCR, DVD
Player, etc.)
2,
Press and hold the conlponent button on tile renlote control that
corresponds to the component you want tile remote to operate
(VCR1, DVD, etc.). While you hold down the component button,
press and hold ON-OFF (when the red light on tile remote turns
on, release both buuons).
3. Press PLAY (the red light on the remote, located below tile ON-OFF
button, starts flashing).
7lie remote is searching tile first set of component codes (there are
20 sets of codes). If the component you want to operate doesn't
turn off automatically afl(.r 5 seconds, press PLAY again (the red
light starts flashing again as the remote searches through the next
set of codes).
Continue pressing PLAY until the component turns off.
4,
Note: If the componer_t doesn '! tz¢rn ojff'q/?er yo*¢'¢,epressed the
I)IMY bz_tto_ 20 time._; the component can't be programmed.
Press REVERSE, w.ait 2 seconds. Repeat this sl(.p until the
component turns back on.
5. 7b finish, press and hold the STOP button until the red light on the
remote turns off.
24