Assembly - NordicTrack E 3800 User Manual

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials untilassembly is completed.Assembly requires the included allen wrench
and your own phillips screwdriver (_, wire cutters _5_ , and rubber mallet _::=:::_."==
Note: The undersideof the treadmill walking belt is coated with high-performancelubricant.During shipping,a
small amount of lubricantmay be transferredto the top of the walking belt or the shippingcarton. This is a normal
conditionand does not affect treadmill performance. If there is lubricanton top of the walking belt, simplywipe off
the lubricantwith a soft clothand a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights(69) until the treadmill is in the positionshown.
Refer to the inset drawing. Insert one of the Extension
Legs (102) into the treadmill as shown. Make sure that
the Extension Leg is turned so the Base Pad (99) is on
the bottom. Note: It may be helpfulto tip the Uprights(69)
forward and tap on the Extension Leg with a rubber mal-
let as you insertthe Extension Leg.
Insertthe other Extension Leg (not shown) in the same
way.
2. Press the Lock Knob Sleeve (70) into the left Upright (69).
Remove the Lock Knob (68) from the Lock Pin (74). Make
sure that the Lock Pin Collar (72) and the Spring (71) are
on the Lock Pin.
Insertthe Lock Pin (74) into the Lock Knob Sleeve (70)
and the left Upright (69).
Tighten the Lock Knob (68) back onto the Lock Pin (74).
68
71
70
72
74
3. With the help of a second person, carefully tip the
Uprights (69) down as shown. Make sure that the
Extension Legs (102) remain in the Uprights.
Attach each Extension Leg (102) with two 1"Screws
(148) and a Base Pad (99) as shown. Note: Attach the
lower Screw (without the Base Pad) first.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position.
Note: One replacement Base Pad (99) may be included.
Use the Base Pad to replace any Base Pad that becomes
worn.
_691
102-1
148
6