Replacing The Memory Module(S) - Dell Inspiron Zino Service Manual

3. Use your fingertips to carefully spread apart the securing clips on each end of the memory-module connector until the module pops up.
4. Remove the memory module from the memory-module connector.
1 tab 2
3 memory module 4

Replacing the Memory Module(s)

CAUTION: If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM 1" before you
install a memory module in the connector labeled "DIMM 2."
1. Follow the procedures in Before You
2. Align the notch in the memory module with the tab in the memory-module connector.
3. Slide the memory module firmly into the slot at a 45-degree angle, and press the memory module down until it clicks into place. If you do not hear the
click, remove the memory module and reinstall it.
NOTE: If the memory module is not installed properly, the computer may not boot.
4. Replace the bottom cover (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
5. Connect your computer and all attached devices to electrical outlets, and then turn them on.
If the message appears stating that memory size has changed, press <F1> to continue.
6. Log on to your computer.
7. To verify that the memory is installed correctly:
®
Windows XP:
Click Start® Control Panel® System.
®
Windows Vista :
Click the Start button
Windows 7:
Click the Start button
8. Check the amount of memory (RAM) listed.
Back to Contents Page
memory-module connector
securing clips (2)
Begin.
Replacing the Bottom Cover).
® Control Panel® System and Maintenance.
® Control Panel® System and Security® System.