Dell Inspiron Zino Service Manual page 34

Back to Contents Page
Power-Button Bracket
Dell™ Inspiron™ 300/400 Service Manual
Removing the Power-Button Bracket
Replacing the Power-Button Bracket
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Power-Button Bracket
1. Follow the procedures in Before You
2. Remove the top cover (see
3. Remove the top bracket (see
4. Remove the optical drive (see
5. Remove the screw that secures the power-button bracket to the drive bay.
1 screw 2 power-button bracket
6. Remove the drive bay (see
7. Disconnect the power-button cable from the connector on the system board.
8. Lift the power-button bracket along with the power-button cable away from the computer.
Replacing the Power-Button Bracket
1. Follow the procedures in Before You
2. Connect the power-button cable to the connector on the system board.
3. Replace the drive bay (see Replacing the Drive
4. Replace the screw that secures the power-button bracket to the drive bay.
Begin.
Removing the Top Cover).
Removing the Top Bracket).
Removing the Optical Drive).
Removing the Drive Bay).
Begin.
Bay).