Dell Inspiron Zino Service Manual page 24

Back to Contents Page
I/O Bezel
Dell™ Inspiron™ 300/400 Service Manual
Removing the I/O Bezel
Replacing the I/O Bezel
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the I/O Bezel
1. Follow the procedures in Before You
2. Remove the top cover (see
3. Remove the bottom cover (see
4. Press and release the tabs on the bottom of the I/O bezel from the slots on the chassis and lift the I/O bezel out of the computer.
1 tabs (3)
Replacing the I/O Bezel
1. Follow the procedures in Before You
2. Align the tabs on the I/O bezel with the slots on the computer and snap into place.
3. Replace the bottom cover (see
4. Replace the top cover (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
5. Connect your computer and all attached devices to electrical outlets, and turn them on.
Begin.
Removing the Top Cover).
Removing the Bottom Cover).
2 I/O bezel
Begin.
Replacing the Bottom Cover).
Replacing the Top Cover).