Salt Indicator; Bypassing The Salt Indicator - Miele G 863 Plus Operating Instructions Manual

Before using for the first time
Salt indicator
When the salt reservoir is empty, the
"Salt-PC" indicator will light, indicating
that it should be refilled with reactiva-
tion sail
0
Bypassing the SaJt indicator
If you have soft water (below 8 gr/gal
(! 40 ppm)), the salt reservoir should
not be filled with salt, The indicator will
remain lit and should be disregarded or
bypassed,
[] Remove the salt reservoir cap,
Looking into the salt reservoir, you will
see the top of the float chamber on the
right hand side, _,
After the reservoir has been filled, the
water softener is automatically reacti-
vated the next time the dishwasher is
started, The "Salt" indicator will be lit
during this process,
[] Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir,
[] Using the needle nose pliers, first pull
the cap, ,'_, off of the float chamber,
then remove the float, _@,
Replace the float chamber cap, push
the chamber back into its upright posi-
tion, and replace the salt reservoir cap,
The "Salt" indicator should no longer be
lit,
16